Broan-NuTone ALLURE QS1 SERIES Manuel d'utilisateur télécharger pdf

Page 1

ALLURE

QS1 SERIES

RANGE H OOD

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you

have questions, contact the manufacturer at the address or telephone

number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from be-

ing switched on accidentally. When the service disconnecting means

cannot be locked, securely fasten a prominent warning device, such

as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to prevent

backdrafting. Follow the heating equipment manufacturer’s guideline

and safety standards such as those published by the National Fire

Protection Association (NFPA), and the American Society of Heating,

Refrigeration and Air Conditioning Engineers (ASHRAE), and the local

code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

6. To reduce the risk of fire or electric shock, do not use this range hood

with an additional speed control device.

7. Ducted fans must always be vented to the outdoors.

8. To reduce the risk of fire, use only metal ductwork.

9. Use with approved cord-connection kit only.

10.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers cause

smoking and greasy spillovers that may ignite. Heat oils slowly on low

or medium settings.

2. Always turn hood ON when cooking at high heat or when cooking

flaming foods.

3. Clean ventilating fans frequently. Grease should not be allowed to

accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the size

of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF

A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal

tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately, EVACUATE AND CALL THE

FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN — You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - violent

steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already

know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

ALLURE

QS1 SERIES

RANGE HOODS

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with

the homeowner.

Homeowner: Operating and

Cleaning information on page 5.

CAUTION

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust hazardous or

explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or unbalanced impel-

lers, keep drywall spray, construction dust, etc. off power unit.

4. For best capture of cooking impurities, your range hood should be

mounted so that the top of the hood is 24-30” above the cooking

surface.

5. Please read specification label on product for further information and

requirements.

TABLE OF CONTENTS

This manual is divided into sections as follows:

“PREPARE HOOD LOCATION”

Run ductwork from roof or wall cap, and electrical wiring from ser-

vice panel - to installation location

“PREPARE THE HOOD”

Get your hood ready for installation

“CONNECT WIRING”

Make electrical wiring connections to hood

“INSTALL HOOD”

Secure hood to cabinet and ductwork - install bulbs and filters

“OPERATION”

How to use the hood controls

“CLEANING”

Keep your hood in top working condition

“SERVICE PARTS”

Part numbers and exploded view of hood components

“WARRANTY”

One-year limited warranty and how to contact us

NOTE If hood is to be installed Non-Ducted:

Purchase a set of (2) non-ducted filters from your

local distributor or retailer and attach them to the

aluminum mesh filters.

Patent No.:

US D450, 829 S

FOR DOMESTIC COOKING ONLY

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - RANGE HOODS

Page 1ALLURE® QS1 SERIESRANGE H OOD !WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:1. Use this unit

Page 2 - RANGE H OOD

Page 10ALLURE® QS1 SERIESRANGE H OOD BRANCHEZ LES FILS D’ALIMENTATION ÉLECTRIQUE1 Branchez le câble d’alimentation du panneau principal (120 V, cour

Page 3 - PREPARE THE HOOD

Page 11ALLURE® QS1 SERIESRANGE H OOD AVERTISSEMENT : Afin de prévenir les risques d’électrocution, interrompez le courant avant de procéder à l’entr

Page 4 - CONNECT WIRING

Page 12ALLURE® QS1 SERIESRANGE H OOD 628001CPage 12PIÈCES DE REMPLACEMENTNO. NO. DU SCHÉMA DE PIÈCE DESCRIPTION2 R740013 Raccord du conduit avec

Page 5 - NON-DUCTED FILTERS

Page 2ALLURE® QS1 SERIESRANGE H OOD CABINETBOTTOMCABINET FRONTHORIZONTAL DUCTACCESS HOLE5¼"5¼"7½"1/8"¾"1315/16" (30&quo

Page 6 - SERVICE PARTS

Page 3ALLURE® QS1 SERIESRANGE H OOD PREPARE THE HOOD3 Remove Wiring Cover from inside the hood. Set cover and mounting screw aside.4 Remove either

Page 7 - DE LA SÉRIE

Page 4ALLURE® QS1 SERIESRANGE H OOD CONNECT WIRINGWARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel

Page 8 - PRÉPAREZ L’EMPLACEMENT

Page 5ALLURE® QS1 SERIESRANGE H OOD WARNING: To reduce the risk of electric shock, disconnect from power supply before cleaning.Aluminum mesh filters

Page 9

Page 6ALLURE® QS1 SERIESRANGE H OOD 628001CWARRANTYSERVICE PARTS KEY NO. PART NO. DESCRIPTION 2 R740013 Damper/Duct Connector (includes hardwar

Page 10 - PRÉPAREZ LA HOTTE

Page 7ALLURE® QS1 SERIESRANGE H OOD !AVERTISSEMENTAFIN DE DIMINUER LES RISQUES D’INCENDIE, D’ÉLECTROCUTION OU DE BLESSURES, SUIVEZ CES DIRECTIVES:1.

Page 11 - FILTRES SAN CONDUIT

Page 8ALLURE® QS1 SERIESRANGE H OOD SOFFITE60 CM À 76 CM AU-DESSUS DE LA SURFACEDE CUISSONARMOIRECONDUIT DE 8, 3 CM X 25, 4 CM(Pour évacuation horizo

Page 12 - GARANTIE

Page 9ALLURE® QS1 SERIESRANGE H OOD 3 Retirez le couvercle du boîtier de distribution de la hotte. Mettez-le de côté avec les vis d’assemblage.4 R

Plus de documents pour Hottes de cuisine Broan-NuTone ALLURE QS1 SERIES

Voir le document Broan-NuTone ALLURE QS1 SERIES Manuel d'utilisateur

Broan-NuTone ALLURE QS1 SERIES Manuel d'utilisateur (6 pages)

Commentaires sur ces manuels

Pas de commentaire

Broan-NuTone ALLURE QS1 SERIES Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Hottes de cuisine Broan-NuTone ALLURE QS1 SERIES. ALLURE® QS1 SERIES RANGE HOODS READ AND Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Hottes de cuisine Broan-NuTone ALLURE QS1 SERIES

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Broan-NuTone ALLURE QS1 SERIES